Auto Channel Change Setting; Manual Channel Change Setting; Set All/Direct Call; Set All Call - Motorola TLKR T8 Owner's Manual

Press the CH/
key to enter the channel setting. Press
OK then press the
Change settings or Manual Channel Change settings.
The Display shows the following:
Auto Channel
Change
Press the CH/
key to enter each setting.
Note:Pressing the CH/
status.

Auto Channel Change setting

Press the CH/
key to enter Group Mode.
Press OK to set the Auto Channel change and the display
will show the current group number. Press OK then press
the or key to select the group channel number press
again the or key to select the group mode in "ALL".
Press OK to confirm and transmit Auto Channel change
command.
Note:Pressing CH/
16
or key to select the Auto Channel
Manual Channel
Change
key will go back to idle
key will go back to idle status.
Manual Channel setting
Press the CH/
key to enter Group Mode. Press OK to
set the Manual Channel setting and the display will show
"MY".
Press OK then press the
channel.
Then, Manual channel setting is available.
Note:Pressing the CH/
status.

Set All/Direct Call

Press the / key in Group mode to enter All/Direct call
setting. At first the user selects a type of call from All Call
transmission or Direct Call setting.
All Call
Transmission
To select the setting, press the
type of a call.

Set All Call

When All Call Transmission " ZYNC" is selected press the
/ key to transmit All Call immediately. Then it sounds
All Call tone to the receiver unit. The display shows TX icon
and Call icon while transmitting.
Note:Pressing the CH/
or key to select the
key will go back to idle
Direct Call
Transmission
or key to select the
key will go back to idle status.