Package Contents; Install The Battery; Battery Level And Low Battery Alert; Charging The Radio - Motorola TLKR T8 Owner's Manual

Congratulations on your purchase of the TLKR T8 radio.
This product is a lightweight, durable radio. Use it at
sporting events to stay in contact with family and friends,
hiking, skiing, outdoors, for vital communication. This
compact, state-of-the-art device is equipped with many
features.

Package Contents

Your package contains two TLKR T8 radios, two belt clips,
one charging cradle, AC adapter, two battery support
brackets, two rechargeable NiMH battery packs and this
reference guide. You may operate the unit with 4 AAA
alkaline batteries (not included).

Install the Battery

Your TLKR T8 radio uses the NiMH battery pack or 4 AAA
alkaline batteries (not included). If alkaline batteries are
used, we recommend using high quality alkaline batteries.
To install the NiMH battery pack:
1. Make sure your radio is OFF.
2. Remove the battery compartment door by pressing the
tab at the bottom of the compartment door, allowing the
door to be removed.
3. Install the NiMH battery pack into the battery compart-
ment. Be certain to follow the + and – symbols in the
compartment. Installing the battery pack incorrectly will
prevent the unit from operating.
4. Replace the battery compartment door.

Battery Level and Low Battery Alert

This unit has a battery level meter on the display to indicate
the status of the batteries. When the battery in the unit is
low, the battery level meter icon
Recharge the NiMH rechargeable batteries immediately.

Charging the Radio

If you use the rechargeable NiMH battery, two TLKR T8
radios can be charged directly or by using the supplied
charging cradle.
Make sure the radio is turned OFF before placing the
radio in the charging cradle. Otherwise the battery level
meter icon will not indicate properly.

Direct Charge

1. Connect the DC adapter's plug to the radio's DC IN 9V
jack and plug the other end to a vehicle's accessory
power outlet.
2. Charge the battery pack for 16 hours.

Using the Charging Cradle

1. Connect the AC adapter to DC IN 9V and to a standard
electrical outlet.
2. Set the charging cradle on the desk or tabletop, and
place the radio in the charging cradle with the keypad
facing forward.
3. Make sure that the LED illuminates. Charge the battery
pack for 16 hours and remove the radio from the
charging cradle after charge.
Note:The charge indicator LEDs will remain on as long
as the radios are left in the charger.
will flash.
5