NEC Video Wall Mount PD02VW MFS 46 55 L Installation And Assembly Manual page 7

Attaching Adapter Brackets to Display
NOTE: Make sure to use largest hole pattern on back of display.
2
Attach adapter brackets (B) to back of display using four M6 x 12 mm socket pin screws (I) with nylon shoulder
washer (H), or four M8 x 15 mm socket pin screws (J) as shown below.
Attaching Adapter Brackets to Pull-Out Mount Assembly
3
Attach adapter brackets (B) to pull-out mount assembly. Slide adapter brackets (B) into position.
Loosely fasten in place using security screw as shown in detail 1.
NOTE: Once display is located in desired position (
4mm allen wrench (K) to lock in place.
B
H
I or J
B
B
2" from center), tighten security screws using
±
7 of 12
ISSUED: 02-21-13 SHEET #: 145-9017-1