Installing Hardware Options; Order Of Installation - Lexmark MX610 User Manual

Additional printer setup
3
Unplug the printer hard disk interface cable from the receptacle in the controller board , leaving the cable attached
to the printer hard disk. To unplug the cable, squeeze the paddle at the plug of the interface cable to disengage the
latch before pulling the cable out.
4
Hold the printer hard disk by the edges, and then remove it from the printer.
5
Close the controller board shield, and then close the access door.

Installing hardware options

Order of installation

CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or more
trained personnel to lift it safely.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
CAUTION—TIPPING HAZARD: Floor‑mounted configurations require additional furniture for stability. You must
use either a printer stand or printer base if you are using a high‑capacity tray and an input option, or more than
one input option. If you purchased a multifunction printer (MFP) that scans, copies, and faxes, you may need
additional furniture. For more information, see www.lexmark.com/multifunctionprinters.
Install the printer and any hardware options you have purchased in the following order:
•
Printer stand
•
Optional 250‑ or 550‑sheet tray
•
Printer
45