How To Replace The Auger Shear Bolt - Craftsman 536.881110 Owner's Manual

8. Remove the four bolts that hold the
bearing plates on each side of the
hex shaft. See Figure 37.
NOTE: Take special note of the
position of the washers and retain-
ing ring on the hex shaft and the
sprocket assembly.
Friction Wheel Hex Shaft
Bearing Bearing
Plate Plate
Figure 37
9. Remove the bearing plate from the
right side. Do not remove the hex
shaft. Leave the hex shaft in posi-
tion. Carefully raise hex shaft just
enough to allow the friction wheel
to be removed.
10. Remove the friction wheel from the
hub. Slip the friction wheel toward
the right off the hex shaft. See
Figure 36.
11. Assemble the new friction wheel
onto hub with the fasteners re-
moved earlier.
12. Install the bearing plate onto the
right side. Make sure the hex shaft
is engaged with both bearing
plates and that the washers and re-
taining ring are installed in the origi-
nal position. See Figure 37.
13. Fasten the bearing plates using
the four bolts removed earlier.
14.
15.
16.
Make sure the hex shaft turns free-
ly.
Attach the speed control rod to the
shift yoke assembly. See
Figure 35.
Check the adjustment of the friction
wheel. See "How To Adjust The
Friction Wheel" in this section.
17. Make sure the friction wheel and the
disc drive plate are free from grease
or oil.
!8. install the bottom panel. See
Figure 33.
19. Tighten the bottom bolts on each
side of the bottom panel.
20. Install the top bolts on each side of
the bottom panel.
21. Connect the spark plug wire.
HOW TO REPLACE THE AUGER SHEAR BOLT
The augers are secured to the auger shaft
with special shear bolts. These shear bolts
are designed to break and protect the ma-
chine if an object becomes lodged in the au-
ger housing. Do not use a harder bolt as the
protection provided by the shear bolt will be
lost.
,_ WARNING: For safety and to
protect the machine, use only
original equipment shear bolts.
.
2.
Move the throttle control to the stop
position. Disengage all controls.
Disconnect the spark plug wire.
Make sure all moving parts have
stopped.
To replace a broken shear bolt, proceed
as follows. Extra shear bolts were pro-
vided in the assembly parts bag.
F-001142J 29