TABLE EXTENSIONS
See Figures 11 - 12,
Table extensionscan be instaflad in either the left or the
rfghtsfdeof the base.
To install:
i
Insertthe ends of the table extensionsinto the holesin
the side of the bass and adjust the extensionsto the
desired length.
• Secure extensionsinplace by positioningthe clamp
bracket under the extensionbeneath the base. Orient
the clamp bracket as shown in figure 12.
•
Using the clamp bracket bolt, securethe clamp
bracket in place.
NOTE: The clamp bracket bolt threadsthrough the
c_ampbrac_,et and tightens againstbracket supporton
bottom of base, securingc_p
bracket ag_nst _ble
extensions.
ROLLER
SUPPORT
See Figure 13.
• Turn the rottersupport upside down.
•
Spin the wing nut on the levelerclockwiseuntilthe
wing nut Is positionedIn the middle of the threads,
•
Screw the leveler into the center brace of the roller
support.
•
Turnthe rollersupport upright.
• W_ththe table extensionssecured in the saw's base.
slide the roller support onto the extensions.
•
Tightenthe wing nut on the back of the rollersupport
secudng it to the table extensions.
• The levelermust sit firmlyon the surfacethe saw is
mounted to. Adjust the leveler up or down as needed.
• Once the leveleris in the proper position,turn the lever
wing nut until the wing nut is t_ghtagainstthe center
brace.
CLAMP
BRACKET
CLAMP
BRACKET SCREW
SAW_'1E'WEO FROM6Ol"rOM
WINQNUT
BRACKET
SUPPORT
BASE
TABLE EXTENSION
ROLLER SUPPORT
Fig. 12
TABLE
EXTENSION
WING NUT
Fig. 13
m
TABLE
SAWBASE
EXTENSION
Fig. 11
_6