Table of Contents
Advertisement
Maintenance
Figure 41
1. Switch screws
2. Nut and bolt
3. Cam
4. Front reference/speed control handle
8. After the cam is adjusted, the lever switch needs
to be checked.
9. Check the gap between the control lever and
switch as shown in Figure 42. The gap needs
to be an 1/8 inch (3mm) with the right motion
control lever in the neutral, operate position.
Figure 42
1. Switch
2. Cam
3. Right motion control lever in the neutral operate position
4. 1/8 inch (3mm)
10. If needed, loosen the screws holding the switch
and adjust the switch.
11. Tighten the switch screws.
Caster Pivot Bearings
Pre-Load Adjustment
Remove dust cap from caster and tighten nyloc nut
until washers are flat and back off 1/4 of a turn
to properly set the pre-load on the bearings. If
disassembled, make sure the spring disc washers are
reinstalled as shown in Figure 43.
1. Spring disc washers
44
Figure 43
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the VANTAGE and is the answer not in the manual?
Questions and answers
My mower has the ECS handles on it, does it require any different steps when changing the hydraulic oil and filter?
The provided context does not mention ECS handles or indicate that different steps are required for changing the hydraulic oil and filter based on handle type. Therefore, based on the available information, no different steps are specified.
This answer is automatically generated
My mower has gotten slower in reverse, what can I do to fix this
To fix a slow reverse issue on an Exmark Vantage mower, follow these steps:
1. Check the bypass valve – Make sure it is closed tightly. A loose valve can cause drive issues.
2. Inspect the drive or pump belts – Look for worn, loose, or broken belts and replace them if needed.
3. Check if belts are off a pulley – Reinstall the belt if it has slipped off and ensure pulleys are in correct working position.
4. Adjust tracking – Turn the left-hand adjustment rod in 1/4 turn increments in the direction needed until the mower tracks correctly.
These steps can help restore proper reverse speed and function.
This answer is automatically generated
Where is the bypass valve on my vantage
The exact location of the bypass valve on the Exmark Vantage is not specified in the provided information. The context only states that the mower is equipped with bypass valves and advises consulting the operator's manual for specific instructions on opening them.
This answer is automatically generated