Table of Contents
Advertisement
Driving the Machine
CAUTION
Machine can spin very rapidly by positioning one
lever too much ahead of the other. Operator may
lose control of the machine, which may cause
damage to the machine or injury.
• Use caution when making turns.
• Slow the machine down before making sharp
turns.
Important: To begin movement (forward or
backward), the brake lever must be disengaged
(pushed forward) before the motion control
levers can be moved or the engine will stop.
When the RH motion control lever is positioned
fully outward (apart), the drive system is in the PTO
disengage position (Figure 8).
Note: The "N" LCD indicator appears when the
RH lever is in the PTO disengage position.
When the RH motion control lever is moved directly
inward (together) the drive system is in the neutral
operate position.
Figure 8
1. LH Motion control lever
2. RH Motion control lever
3. RH Motion control
lever in PTO disengage
position
4. Reverse
5. Rear reference bar
Driving Forward
1. Make sure the motion control levers are in the
neutral position.
2. Release the parking brake.
3. To move forward in a straight line, move both
levers forward with equal pressure.
6. Neutral
7. Forward
8. Front reference/Speed
control bar
9. Front of unit
To turn left or right, pull the motion control lever
back toward neutral in the desired turn direction.
The machine will move faster the farther the
motion control levers are moved from the neutral
position.
4. To stop, position both motion control levers in
the neutral operate position.
Driving in Reverse
1. Move the motion control levers to the neutral
operate position.
2. To move rearward in a straight line, slowly move
both levers rearward with equal pressure.
21
Operation
Figure 9
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the VANTAGE and is the answer not in the manual?
Questions and answers
My mower has the ECS handles on it, does it require any different steps when changing the hydraulic oil and filter?
The provided context does not mention ECS handles or indicate that different steps are required for changing the hydraulic oil and filter based on handle type. Therefore, based on the available information, no different steps are specified.
This answer is automatically generated
My mower has gotten slower in reverse, what can I do to fix this
To fix a slow reverse issue on an Exmark Vantage mower, follow these steps:
1. Check the bypass valve – Make sure it is closed tightly. A loose valve can cause drive issues.
2. Inspect the drive or pump belts – Look for worn, loose, or broken belts and replace them if needed.
3. Check if belts are off a pulley – Reinstall the belt if it has slipped off and ensure pulleys are in correct working position.
4. Adjust tracking – Turn the left-hand adjustment rod in 1/4 turn increments in the direction needed until the mower tracks correctly.
These steps can help restore proper reverse speed and function.
This answer is automatically generated
Where is the bypass valve on my vantage
The exact location of the bypass valve on the Exmark Vantage is not specified in the provided information. The context only states that the mower is equipped with bypass valves and advises consulting the operator's manual for specific instructions on opening them.
This answer is automatically generated