Table of Contents
Advertisement
Operation
Adjusting the Cutting Height
The cutting height of the mower deck is adjusted
from 1 to 5 inches (2.5 cm to 12.7 cm) in 1/4 inch
(6.4 mm) increments.
1. Stop the machine and move the motion control
levers to the neutral position.
2. Disengage the PTO.
3. Raise and lock the deck to the 5 inch (12.7 cm)
transport position.
The deck is raised by pulling the deck lift handle
rearward and to the right to place it into the
transport lock position.
Figure 14
1. Transport lock position
2. RH Motion control lever
Note: When changing the cutting height
positions, always come to a complete stop
and disengage the PTO.
4. Insert the height adjustment pin into the hole
corresponding to the desired cutting height.
See the decal on the side of the deck lift plate for
cut heights (reference Figure 15).
5. Pull the deck lift handle rearward and to the left
and slowly allow the deck to lower to the cutting
height.
3. Front reference/speed
control bar
4. Deck lift handle
1. Height adjustment pin
2. Height of cut holes
Transporting
Transporting a Unit
Use a heavy-duty trailer or truck to transport the
machine. Lock brake and block wheels. Securely
fasten the machine to the trailer or truck with straps,
chains, cable, or ropes. Be sure that the trailer or truck
has all necessary lighting and marking as required by
law. Secure a trailer with a safety chain.
CAUTION
This unit does not have proper turn signals,
lights, reflective markings, or a slow moving
vehicle emblem. Driving on a street or roadway
without such equipment is dangerous and
can lead to accidents causing personal injury.
Driving on a street or roadway without such
equipment may also be a violation of State laws
and the operator may be subject to traffic tickets
and/or fines.
Do Not drive a unit on a public street or roadway.
24
Figure 15
3. Deck lift handle
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the VANTAGE and is the answer not in the manual?
Questions and answers
My mower has the ECS handles on it, does it require any different steps when changing the hydraulic oil and filter?
The provided context does not mention ECS handles or indicate that different steps are required for changing the hydraulic oil and filter based on handle type. Therefore, based on the available information, no different steps are specified.
This answer is automatically generated
My mower has gotten slower in reverse, what can I do to fix this
To fix a slow reverse issue on an Exmark Vantage mower, follow these steps:
1. Check the bypass valve – Make sure it is closed tightly. A loose valve can cause drive issues.
2. Inspect the drive or pump belts – Look for worn, loose, or broken belts and replace them if needed.
3. Check if belts are off a pulley – Reinstall the belt if it has slipped off and ensure pulleys are in correct working position.
4. Adjust tracking – Turn the left-hand adjustment rod in 1/4 turn increments in the direction needed until the mower tracks correctly.
These steps can help restore proper reverse speed and function.
This answer is automatically generated
Where is the bypass valve on my vantage
The exact location of the bypass valve on the Exmark Vantage is not specified in the provided information. The context only states that the mower is equipped with bypass valves and advises consulting the operator's manual for specific instructions on opening them.
This answer is automatically generated