Mounting the Antenna
3.
Situate the antenna bracket against the antenna, so that the end against the antenna pivots in
the same plane as the desired polarization. For example, if using vertical polarization, this
antenna bracket end should pivot up and down. If using horizontal polarization, this antenna
bracket end should pivot from side‐to‐side.
4.
Use the four (yellow) hex nuts, to secure the antenna bracket to the back of the antenna.
5.
Rotate the pivot of the bracket end attached to the antenna to adjust the antenna position.
Lock bracket in desired position by tightening nuts on either side of bracket end with
wrenches.
Mounting the Antenna to a Wall
Figure 3‐12 illustrates how to attach the 5.8 GHz panel antenna to a wall. Table
components for this procedure.
Figure 3-12
Table 3-11 RoamAbout 5.8 GHz Panel Antenna Wall Mounting Components
#
1
2
3
4
5
3-24 Antenna Installation
Mounting the RoamAbout 5.8 GHz Panel Antenna to a Wall
Component
Antenna (RBTES-AH-P23M)
Antenna bracket
Wall
Screw holes in wall
Screws for attaching antenna to the wall (user supplied)
3‐11 lists the