Table of Contents
Advertisement
Mounting the Access Point
Mounting on a Wall
To mount the Access Point 3000 on a wall, perform the following steps:
1.
Locate at least two mounting holes/slots on the mounting bracket that line up with a wall stud.
2.
Use two screws to secure the flat side of the mounting bracket to the wall stud. Use plastic
anchors, or self‐anchoring screws (not included) to secure the mounting bracket to the
wallboard, as shown below.
3.
Slide the access point over the mounting bracket to locate the three raised tabs, as shown in
the following figure.
2-2 Hardware Installation
Advertisement
Table of Contents
