Light Bulb - Eureka 6980 Series Owner's Manual

How to Replace Worn Belt or Light Bulb
Note: Disconnect power cord and wands from electrical hose before replacing belt or bulb. Belt pulleys can become
hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
1. Remove two screws from bottom side. Turn over to
grasp hood near handle socket and lift forward.
Replace headlight bulb, if necessary. Support socket
with one hand and push light bulb into socket; turn to
release. Place new light bulb into socket; turn to secure.
Push light bulb and socket back so bulb will not touch
lens cover. Use GENUINE EUREKA replacement bulb,
59224.
Continue to step 2 to change belt. Skip to step 7
and 8 to replace hood on motorized nozzle.
2. Remove two screws located in front of the light bulb
and lift up to remove the brush roll cover.
Motor Pulley
3. Lift out brush roll; replace new belt around brush roll
pulley.
4. Return brush
roll into base.
5. Rotate belt onto motor pulley.
6. Replace brush roll cover.
Ridge
7. Tilt cover over ridge and push down.
8. Secure with screws on underside (refer to 1).
Look for the
Use GENUINE EUREKA replacement belt, 52201B.
Brush
{
Roll
Pulley
symbol.
11