Light Bulb; Problem Solving - Eureka 7700 Series Owner's Manual

PROBLEM SOLVING

NOTE: Turn off the switch and unplug the electrical cord before servicing.
PROBLEM
Motor will not start.
Does not clean the carpet
or floor.
No suction at the end of
the hose.
Motor suddenly stops.
Headlight not working.
Noise from the brush roll
area.
Cleaner is hard to push.
Brush roll will not turn.
Burning smell.
Cleaning height knob will
not turn.
Missing parts.
Questions?
12
CAUSE
3
Electric Plug
3
Disposable Dust Bag
3
Belt
3
Brush Roll
3
Hose
3
Carpet/Floor or Tools
Selector
(7900 Series only)
3
Hose Converter
(7700
Series only)
3
Carpet/Floor or Tools
Selector
(7900 Series only)
3
Disposable Dust Bag
3
Hose
3
Attachment Door or
Hose Connection on
Base
3 Thermal Cut Off
3

Light Bulb

3
Brush Roll
3
Belt
3
Cleaner Height Setting
3
Belt
3
Belt
3
Belt
3
Cleaner Height Setting
SOLUTION
Push plug securely into outlet.
Try another outlet.
Check circuit breaker.
Change the bag. Hint: If picking up fine dust, the
bag may not look full but a fine substance tends
to reduce suction when it blocks the airflow
through the paper bag.
Replace a cut, loose or out of shape belt.
Clean hair and thread from bristles and end
cap area. Replace brush roll if bristles are worn.
Remove any clogs from the hose that restrict
the airflow.
Push selector switch back. This directs the
suction to the carpet or floor.
Hose converter has to seat inside the attachment
door. Hint: Place converter notch to the back of
the cleaner.
Push selector switch forward. This directs the
suction to the hose and tools.
Change the bag. Hint: If picking up fine dust, the
bag may not look full, but a fine substance tends
to reduce suction when it blocks the airflow
through the paper bag.
Remove any clogs from the hose that restrict the
airflow. Check both ends of the hose.
Remove bottom plate and clean debris from the
attachment door area or around the hose
connection.
Refer to page 4.
Replace light bulb.
Remove bottom plate and clean debris
from the brush roll area.
Replace a cut, loose or out of shape belt.
Turn adjustment knob to a higher position.
Hint: Put handle in operating position. Tilt the
cleaner back to raise the front wheels off floor.
Then turn the knob.
Replace a cut, loose and out of shape belt.
Replace cut, loose or out of shape belt.
Replace cut, loose or out of shape belt.
Hint: Put handle in operating position. Tilt the
cleaner back to raise the front wheels off floor.
Then turn the knob.
Call 1-800-438-7352 between 8 a.m. and 4:45 p.m.
central standard time, Monday-Friday. Know
the model and serial number when you call.
Call 1-800-282-2886 7 a.m. to 8 p.m. Monday
through Saturday. Know the model and serial
number when you call.