Table of Contents
Advertisement
How To Change or Clean
Open filter cover by lifting up on
latches and pulling filter cover out
and away from the cleaner.
Use GENUINE EUREKA
side of filter under warm, low pressure water being careful not to get the clean side
wet (this increases drying time). Do not put damp filter back in vacuum cleaner.
Allow to thoroughly air dry.
Use GENUINE EUREKA Final filter, 61262. The final filter can be cleaned. Run under water and allow to thoroughly air dry.
How to Replace Worn Belt or Light Bulb
NOTE: Disconnect power cord and wands from electrical hose before replacing belt or bulb. Belt pulleys can become
hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
1. Remove two screws from bottom side. To turn over,
grasp hood near handle socket and lift forward.
Replace headlight bulb, if necessary. Support socket
with one hand and push light bulb into socket; turn to
release. Place new light bulb into socket; turn to secure.
Push light bulb and socket back so bulb will not touch
lens cover. Use GENUINE EUREKA replacement bulb,
59224.
Continue to step 2 to change belt. Skip to step 7
and 8 to replace hood on motorized nozzle.
2. Remove two screws located in front of the light bulb
and lift up to remove the brush roll cover.
Motor Shaft
3. Lift out brush roll; replace new belt around brush roll
shaft.
Washable HEPA
Clean or replace washable HEPA
filter. Clean or replace final filter in
filter cover and close cover.
washable HEPA
filter, 61053. To clean filter rinse dirty
Filter and Final Filter
4. Return brush
roll into base.
5. Rotate belt onto motor pulley.
6. Replace brush roll cover.
Ridge
7. Tilt cover over ridge and push down.
8. Secure with screws on underside (refer to 1).
Look for the
Use GENUINE EUREKA replacement belt, 52201C.
(Model 6999
Final Filter
(underneath
side)
Ensure the filter cover is
securely fastened.
Brush
Roll
Pulley
symbol.
only)
9
Advertisement
Table of Contents
