Advertisement
3. To turn the power OFF,
push the ON/OFF switch
panel down (Fig. 16).
4. To lock switch
in the OFF
position,
push the ON/
OFF switch
panel down
to OFF position,
and
remove the safety
key
from the switch
panel.
WARNING:
Never leave
a tool unattended
while it is
running or before it comes to
a complete
stop.
Circuit
Breaker
When the switch-assembly
current exceeds a safe level,
it will overload the circuit,
and the circuit breaker will
trip. Press the circuit-breaker
button to reset the switch
assembly
(Fig. 17).
FOLDING WORK STAND
DOWN FOR STORAGE
Fig. 16
I Fig. 17
I
Please refer to Fig. 1 to Fig 11
on pages 11-15.
NOTE: Remove any
workpieces,
clamps,
or other accessories.
1. Remove the bench-top
power tool from Work stand.
2.
Keep the Caster Wheels in the locked position
by pushing the Locking Lever
"DOWN" (Fig. 11).
3.
Loosen the work stand's Clamping
Knobs.
4.
Grasp the set-up adjustment
handle while applying
pressure to the support
bar with your foot.
5.
With your foot still on the support
bar, loosen the two red locking knobs and
pull the left knob out (Fig. 5).
6.
Lower the tabletop
assembly.
_,
DANGER:
Make sure that your foot is always on the support bar until the
Tabletop Assembly is lowered completely. Failure to obey this safety warning WILL
result in the Support Bar springomg up accidentally, which that may lead to death or
serious injury to yourself or to others.
1
22335
Manual
Revised 07-1203
Page 18
Advertisement
