Unpacking; Assembly; Unfolding And Setting Up The Tool Work Stand; Rules For Safe Operation - Craftsman 320.19730 Operator's Manual

ADDITIONAL RULES FOR SAFE OPERATION cont.
7 ALWAYS check the tool work stand and the power took you are using with it for
damaged parts_ Before further usa of the tool a guard or other part that is damaged
should be carefully checked to delermlne if it will operate properly and perform its
intended funclion, Check for mtsalignment or binding of moving parts, breakage
of parts, and any olher condition that may affect the leers operation A guard or other
pad that Is damaged should be propedy repaired or replaced aL a Sears Service Center.
8, INSPECT and remove all nails from lumber before using a power tool
9, SAVETHESE INSTRUCTIONS. Refer to them frequently and use them to instruct
others who may use this tool stand. If someone borrows this tool stand, make sure they
have these instructions also
Alter taking the Work Stand out at the box, check !or misalignment or binding of moving
parts, bending or breakage of parts, and any other condition that may affect the Toot Work
Slend'e operation, If any part is damaged, return the Too] Work Stand to your nearest Sears
slore or Craftsman outlet to have the Work Stand rep}aced,
Z_ WARNING:
If any parts are bent or broken, DO NOT attempt to set up
ToolWork Stand, DO NOT attempt to mount and use any power tool on e
defective TooI Work Stand. Failure to do so could result in possible serious
tnJury_
UNFOLDING AND SETTING UP THE TOOL WORK STAND (Flgso 1-15)
t Afteryou take the
ToolWork Stand out of carton,
place it fiat on floor in front
of your feet as shown.
Ftg_ 1