Tool Use And Care Safety; Electrical Safety - Craftsman 320.19730 Operator's Manual

PERSONAL SAFETY conL
8o ALWAYS SECUREYOUR WORK= Use clamps or a vise to hold work when praclicaI.
it is safer than _Jsing your hand and frees both hands to operate tool
9_,USE SAFETY EQUIPMENT. Always wear eye protection Dust mask. non-skid safety
shoos, hard hat, or hearing protection must be used for appropriate conditions,
I0, ALWAYS be sure the tool work stand is sat up on a flat solid surface.
This enables better control of lhe power tool that Is attached to the wo_k stand in
unexpected situations
TOOL USE AND CARE SAFETY
Z_ WARNING:
BE SURE to
read,
understand and follow all safety rutes and
operating Instructions in thls manusl and the operator's manual of any bench top
power tool you use with this Universal Bench Top Tool Work Sland, Failure to do
so may result in e|ectric shock, fire and I or serious personal injury.
1, ALWAYS use clamps or other practical ways to secure and support the workpioee
to a stable platform_ Holding the work by hand or against your body is unstabte and
may lead 1o less of conlrol,
2 DO NOT force the tool. Use the correct tool and bit for your application. The correcl
tool and bit will do lho job bettor and safer at the rate for which it is designed,,
3 DO NOT use the tool tf switch does not turn It '+On" or"Off". Any tool that cannot bo
controlled with the sw_lch ts dangerous and must be repaired
4 DISCONNECT the plug from the power source before making any adjustments,
changing accessories or storing the tool. Such preventive safety measures reduce
the risk of starting the tool accidentally,
5 NEVER leave the toot running. ALWAYS turn it off,, DO NOT leave the tool until it
comes to a complete stop,
6 STORE Idle tools out of the reach of children and other untrained persons,, Toots
are dangerous in the hands of untrained users,
7 MAINTAIN tools with oare. Keep cutting tools sharp and cloam Properly maintained
loots with sharp cutting edges are less I_kely to bind and are easier to oontrol
8 CHECK for mfsalignment or binding of moving parts, breakage of parts, and any
other condition Ihat may affect the roof's operation I! damaged, have the Iool serviced
before using Many accidents are caused by poorty mainlained lools.
g USE ONLY accessories that are recommended for the tool being used. Accessories
that may be suitable {m' one loof may become hazardous when used on another Joel.
ELECTRICAL SAFETY
Z_ WARNING:
When connecting your bench top power tool to e power supply, ]
do not permit fingers to touch the terminals of plug when installing or removing |
the plug from the outlet.