Craftsman 320.19730 Operator's Manual page 15

MOUNTNG BENC H TOP TOOL
SUCH AS ATABLE SAW OR PLANER TOTHETOOLWORK STAND (Fig. 18)
! This method of mounting is used for tools that do not fit the pre-slamped tool
mounting slots in the Table Top Assembly el the Tool Work Sland, Examples
would be Scoot[or Saw, Drilt Press, Disc/Belt Sander, Planer, Bench Grinder.
Band Saw, and Rle Culling Wet Saw.
2. For lhts method, a sheet of plywood 16114X 29VB X _/4-inch tl_ick ts recommended
3. This method of mounting requires two sets of mounting holes;
One set for mounting the tool to the plywood, and
Another set for mounting the plywood and toot to
tile pre'-stamped slols in the Table top Assembly of
the Tool Work Sland
4 Place the plywood onto the Table Top Assembty of the Too[ Work Stand and mark four
holes wilhin tl_e pro-stamped slotted areas on lhe Table Top Assembly, Use bolls,
washers and nuts as shown in Fig.. !8 to attach the plywood to the table lop assembly,.
NOTE: BE SURE the Bolls are long enough to go through plywood, table top
assembly and nut.
5 Mount the bench top tool to the plywood using the holes tn the base of the too!,
or lollow the template in the tool's operator's manual., Use the boils recommended
in your bench top leers manual to connect the bench lop tool to lhe plywood.,
NOTE: Bolts should be long enough to go through base of tool, plywood, and nut.
Fig_ 18plywood
; ' . .,/,Boat head
• ' _ '-" ' ,_ WARNING:For somebench
top tools (such as a saw). a hoZe
must be provided in the plywood
table top under the saw to allow
sawdust to fail through to redtfce
the possibility o_ fire or damage to
the saw, ALWAYS BE SURE to
read and follow the instructions
provided in the beech power 1eel's
operator's manual.
15