Fan Speed - COMFORT-AIRE BGE-123A Owner's Manual

Operating Instructions
The controls will look like one of the following.
-FAN SPEED
• Every time you push this button, it advances the setting as follows: {High[ F2 ] _ Low[ F1 ] _ High[ F2 ]}
Coom q
Energy @
Saver
Fan •
Heat @ Timer
C.TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature
setting will raise 2°F after 30 min., and once again after another
30 rain.
• Push Timer button to advance setting from 1Hour * 2Hours , ...
12Hours maximum.
- START TIME
• If unit is off, use Timer to set number of hours before unit starts.
• Push Timer button to advance setting from 1Hour , 2Hours * ...
,12Hours maximum.
MODE
REMOTE CONTROL SIGNAL
RECEIVER
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of
60°F to 86°F by increments of I°F.
• The setting appears in the display.
POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button
again.
• This button takes priority over any other button.
- Pushthis buttonto shift modeof operationfromCOOL * ENERGY SAVER * FAN , HEAT
- COOL:
• Fan runs continually for normal cooling operation.
- ENERGY SAVER:
• Thefan stopswhenthe compressor stopscooling.Approximately e very3 minutes the fanwill turn onandthe unit will
checkthe roomairtemperature to determineif coolingis needed.
- FAN:
• Fan-only operation.
- HEAT:
• Fan runs continually for normal heating operation.
_d after an electrical power failure, the unit will begin to run at its last setting, j
]
18 Room Air Conditioner