Generac Power Systems 8KW Owner's Manual page 2

iNTRODUCTiON
Thank you for purchasing this compact, high per-
formance, air-cooled, engine-driven generator. It is
designed to automatically supply electrical power to
operate critical loads during a utility power failure.
This unit is factory installed in an all-weather, metal
enclosure that is intended exclusively for outdoor
installation. This generator will operate using either
vapor withdrawn liquid propane (LP) or natural gas
(NG).
NOTE:
This generator is suitable for supplying typical
residential loads such as Induction Motors (sump
pumps, refrigerators, air conditioners, furnaces,
etc.), Electronic Components (computer, monitor,
TV, etc.), Lighting Loads and Microwaves.
@ READ THIS MANUAL THOROUGHLY
If any portion of this manual is not understood, con-
tact the nearest Dealer for starting, operating and
servicing procedures.
Throughout this publication, and on tags and decals
affixed to the generator, DANGER, WARNING,
CAUTION and NOTE blocks are used to alert person-
nel to special instructions about a particular opera-
tion that may be hazardous if performed incorrectly
or carelessly. Observe them carefully. Their defini-
tions are as follows:
After this heading, read instructions that, if not
strictly complied with, wi[[ result in serious person-
al injury, including death, in addition to property
damage.
-_
WARN|NG
_k-
After this heading, read instructions that, if not
strictly complied with, may result in serious person-
al injury or property damage.
& CAUTION A-
After this heading, read instructions that, if not
strictly complied with, could result in damage to
equipment and/or property.
NOTE:
After this heading, read explanatory statements
that require special emphasis.
These safety warnings cannot eliminate the haz-
ards that they indicate. Common sense and strict
compliance with the special instructions while
performing the service are essential to preventing
accidents.
Four commonly used safety symbols accompany the
DANGER, WARNING and CAUTION blocks. The type
of information each indicates follows:
/_ This symbol points out important safety infor-
mation that, if not followed, could endanger
personal safety and/or property of others.
This symbol points out potential explosion haz-
ard.
Z_ This symbol points out potential fire hazard.
/_ This symbol points out potential electrical shock
hazard.
The operator is responsible for proper and safe use
of the equipment. The manufacturer strongly recom-
mends that the operator read this Owner's Manual
and thoroughly understand all instructions before
using this equipment. The manufacturer also strong-
ly recommends instructing other users to properly
start and operate the unit. This prepares them if they
need to operate the equipment in an emergency.
@ CONTENTS
This manual contains pertinent owner's information
for these models:
. 7 kW NG, 8 kW LR single-cylinder GH-410 Engine
. 9 kW NG, 10 kW LR V-twin GT-530 Engine
. 12 kW NG, 12 kW LR V-twin GT-990 Engine
. 13 kW NG, 14 kW LR V-twin GT-990 Engine
. 16 kW NG, 16 kW LR V-twin GT-990 Engine
. 16 kW NG, 17 kW LR V-twin GT-990 Engine
. 18 kW NG, 20 kW LR V-twin GT-999 Engine
@ OPERATION AND MAINTENANCE
It is the operator's responsibility to perform all safety
checks, to make sure that all maintenance for safe
operation is performed promptly, and to have the
equipment checked periodically by a Dealer. Normal
maintenance service and replacement of parts are the
responsibility of the owner/operator and, as such, are
not considered defects in materials or workmanship
within the terms of the warranty. Individual operating
habits and usage contribute to the need for mainte-
nance service.
Proper maintenance and care of the generator ensures
a minimum number of problems and keep operating
expenses at a minimum. See a Dealer for service aids
and accessories.
@ HOW TO OBTAIN
SERVICE
When the generator requires servicing or repairs,
contact a Dealer for assistance. Service technicians
are factory-trained and are capable of handling all
service needs.
When contacting a Dealer about parts and service,
always supply the complete model number and serial
number of the unit as given on its data decal, which is
located on the generator. See section "The Generator"
for decal location.
Model No. Serial No.