Asus PIKE 9230 User Manual page 29

Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Configure->Select free disksCreate Virtual Disk
HBA 0: Marvell 0
Virtual Disks
├
Free Physical Disks
└
* ├ PD 0: ST3160812AS
* └ PD 8: ST3160812AS
Help
Virtual disk configurations.
ENTER: Select
4. Use the up or down arrow key to move the selection bar and press <Enter> to
configure further RAID settings.
RAID Level: Select a RAID Level. Configuration options: [RAID 0] [RAID 1]
[RAID 10]
Stripe Size: Specifies the size of single data block on the virtual disk. In general,
a larger stripe size is recommended for applications requiring large data transfers
such as audio, video, and graphics. A smaller stripe size is better for applications
with content in much smaller size, such as e-mails and documents.
Configuration options: [32K] [64K]
Gigabyte Rounding: In the event of a single physical disk failure in a RAID 1
virtual disk, Gigabyte Rounding allows the replacement physical disk to be of a
size slightly smaller than the existing physical disk. The capacity of the rebuilt
virtual disk equals to the size of the smaller physical disk included in the RAID 1
array. The configuration options represent the tolerance value of drive capacity
difference.
Configuration options: [None] [1G] [10G]
Name: Enter a name with 1–10 letters (no special characters) for the RAID
array.
Move the selection bar to Next and press <Enter>. The following warning
5.
message appears:
Create Virtual Disk
Do you want to create this virtual disk ?
Press <Y> to create the RAID array, or press <N> to cancel. The new RAID
array appears under Virtual Disks, as shown in the image below.
ASUS PIKE 9230
RAID Level
Max Size(MB)
Stripe Size
Gigabyte Rounding : 1G
Quick Init
Name
Threshold(%)
Next
▶
F10: Exit/Save ESC: Return
Yes No
: RAID 0
: 305253
: 64KB
: Yes
: Default
: 90
▶
3-9