Cf_Sharp Command; Cf_Gamma Command; Cf_Wbal- Command - Sanyo PLC-WM5500/L - 5500 Lumens Manual

PLC-WM5500/WM5500L Expand Serial Command Functional Specifications
8.4.5

CF_SHARP Command

Command "CF_SHARP_%1" [CR]
"000-031"--------------- Directly specify setting value of Sharpness
%1 "UP"--------------------- Increment setting value of Sharpness by 1
"DN"--------------------- Decrement setting value of Sharpness by 1
Set user controlled value of Sharpness (Available only in the normal Power ON
status)
Details The value set by this command will not be stored in the projector's memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
8.4.6

CF_GAMMA Command

Command "CF_GAMMA_%1" [CR]
"000-015"---------------- Directly specify setting value of Gamma
%1 "UP"---------------------- Increment setting value of Gamma by 1
"DN"---------------------- Decrement setting value of Gamma by 1
Set user controlled value of Gamma (Available only in the normal Power ON
status)
Details The value set by this command will not be stored in the projector's memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
8.4.7

CF_WBAL- Command

Command "CF_WBAL-%1_%2" [CR]
"R" --------- RED
%1 "G" --------- GREEN
"B" --------- BLUE
"000-063"------ Directly specify value of Color selected in %1 of White Balance.
%2 "UP"-------- Increment setting value of Color specified in %1 of White Balance by 1
"DN"------- Decrement setting value of Color specified in %1 of White Balance by 1
Set value of Color specified in %1 of White Balance (Available only in the normal
Power ON status)
Details
The value set by this command will not be stored in the projector's memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code"[CR]
20/88