Before You Start; Operating The Dishwasher; Adding A Forgotten Item - Amana ADB-1 Use & Care Manual

Before You Start
. Don't prerinse. Simply scrape off any bones or
large food particles.
. If connected to a food waste disposer, make certain
the disposer is empty before starting the
dishwasher.
. Scrape off tomato-based food soils (see page 10).
. Remove certain foods such as mustard,
mayonnaise, lemon juice, vinegar, salt or dressings
from stainmess steem flatware as soon as possibme°
These foods may cause rusting and pitting if allowed
to remain in contact with the surface for an extended
period of time.
Operating the Dishwasher
1. After loading the dishwasher and adding detergent,
select the desired cycle and options by pressing
the pads. The indicator lights for the selected cycle
and options will illuminate. To cancel an option
press the pad again.
2. To start a cycle, close the door until it latches then
press the START!Cancem pad once. After a pause,
the fill will begin. The display countdown (select
models} will flash until START!Cancem is pressed.
3.
To cancel a running cycle, press the
START/Cancel pad once. The dishwasher will
drain, then shut off. To turn the dishwasher off
without draining, press the START/Cancel pad
twice. To prevent unplanned cycle or option
changes, these selections are "locked in" after 1
minute.
. If a cycle pad is pressed after the controls have
been "locked in", the light above the current cycle
will flash three times.
Adding a Forgotten item
For best cleaning, the forgotten item should be added
early in the cycle.
1. Grasp door handle and unlatch door without
opening completely. All lights will flash to indicate
that the cycle is suspended.
2. Wait for the water circulation to stop.
3. Open the door and add the item.
4. Close and latch the door. Lights will stop flashing
when the door is properly shut. After a slight delay,
the cycle resumes automatically at the point of
interruption.
If START/Cancel is not pressed within 30
seconds of choosing your cycle, the dishwasher
will turn off.
The dishwasher remembers your last cycle so you
do not have to reset the cycle each time. To start
the dishwasher using the same cycle and options
selected on the previous wash, just press the
START!Cancel pad.
. If the door is opened during a running cycle,
there may be up to a 30 second delay before the
dishwasher restarts after dosing the door.
. Extended interruption of the wash cycle is not
recommended.
2