Amana ADB-1 Use & Care Manual page 14

Uterus not properly dried/
moisture is present on the
dishwasher interior after the
dry cyde
Dishware is chipped
Sanitized light does not
illuminate at the end of the
cycme (semect modems)
.....
, Be sure Heated Dry is selected.
, Water droplets may form on the inner door as part of the drying process.
, Use a rinse aid separate from the detergent like Jet Dry* or Cascade Rinse Aid*
regularly, to improve drying. Turn the rinse aid selector toward the MAX setting.
, Check water temperature. Incoming water should be 120° F (49° C}.
, Select Sanitize.
, Increase detergent amount to match water hardness (pg. 5}.
, Load properly. ,(pg. 3-4}
, Plastic and items with non-stick surfaces are difficult to dry because they have a
porous surface which tends to collect water droplets. Towel drying may be necessary'.
, Glasses and cups with concave bottoms hold water and require towel drying. Locate
these items on the more slanted side of the rack for improved results.
, Load dishes according to instructions so they do not strike each other (pg. 3-4}.
° Washing fine antique china!crystal in the dishwasher is not recommended.
° Do not load glasses over the tines.
° Do not overload.
, Sanitize was not selected.
° Sanitization can only be achieved with the Auto Wash (select models}, Heavy Wash,
Normal Wash or Quick Wash cycles.
° Sanitization may not be achieved if there is an interruption of the cycle, power failure
or if incoming water temperature is below 120° F (49° C}.
*Brand names are trademarks of the respective manufacturer.
13