GE JGS968 Owner's Manual page 15

Usingthe clock, timer and control lockout, vvvvw.GEAppliances.co
ii ii ii ili!;!i)
Make sure the clock is set to the
correct time of da_
ToSet the Clock
The clock must be set to tile correct time
of dm fin" tile autonmfic o',en tinting
flmctions to work properly. Tile time of
da) cannot be changed during a timed
baking or self=cleaning cycle,
[] Touch tile
CLOCK pad.
[] Touch tile number pads.
[] Touch the START pad.
[]
The timer is a mflTutetimer onI,A
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59mflTutes.
ToSet the Timer
Touch tile
KITCHEN TIMER
ON/OFF pad,
Touch tile number pads tmfil tile
_lIllO/lnt of time yell want shows
in tile display: For example, to set
2 hom_ and 45 minutes, touch 2, 4
and 5 in that ordex: If you make a
mistake touch tile KITCHEN
TIMER
ON/OFF pad and begin again.
[] Touch tile
STARTpad.
After touching theSTART pad,SETdisappears,
this tellsyouthetl_ne is counting down,although
thedisplay doesnot change untiloneminutehas
passedSeconds wi//notbe shownb thedisplay
untilthe/astmbute iscounting down.
[] _,_ hen tile timer reaches :00, tile
control will beep 3 times followed
by one beep eve_ T 6 seconds tmtil
tile KITCHENTIMERON/OFF pad
is touched.
The &secondtonecanbe canceled by followlw
thestepsb theSpecial f eatures of youroven
control s ectionunderTones a t theEndeta
Timed Cycle.
ToReset the Timer
If tile display is st.ill shoMng tile time
remaining, you may change it by
touching tile KITCHEN TIMER ON/OFF pad,
then touch tile number pads tmtil tile
time w_u want appea_ in tile displa>
If tile remaining time is not in tile display
(clock, delay start or cooking time are in
tile display), recall tile remaining time by
touching tile
KITCHENTIMERON/OFF
pad
and then touching tile ntli//ber pads to
entei" tile new [lille veil want.
ToCancel the Timer
Touch tile KITCHEN TIMERON/OFF
pad twice.
LOCK/UNLOCK HOLD 3 SECONDS
Control Lockout
Your c ontrolwill allowyoutolockout thetouch
padsso theycannotbeactivated whenpressed
To hmk/tmlock tile controls:
[] Touch
tile 9 and Opads at tile same
time fin 3 seconds, tmtil tile displa)
shows LOC ON.
[] To unlock tile control, touch tile 9
and
0pads
at tile sanle tinle for 3
seconds, until tile display shows
LOCOFF.
When this teatm'e is on and tile touch
pads
are touched,
tile control will beep
and tile display will show LOCON.
Thecontrollockout m odeaffectsall touch
pads.Notouchpadswi// workwhenthis
feature is activated
Theadjustment w iii be retalhedln memory
after a powerfailure.
15