Ricoh Aficio GX2500 Support Manual page 15

Product Support Guide
Version 1.1 (01/08/08)
Registration
Key Repeat
Paper Feed Test*
De-condensation*
System
Auto Continue
Sub Paper Size
Energy Saver
Notify by Email*
Unit of Measure
Ink CU Replace*
Env. Slctr Alert
Host Interface
I/O Timeou
Network Setup
USB Setting
Language
MODEL: J015
Adjusts the print starting point for each paper tray. Use the Nozzle Check test
pattern as reference.
Enables/disables repetition of a key pushed and held down on the operation
panel.
Feeds and ejects 1 blank sheet of paper to remove moisture inside the machine.
Feeds and ejects 3 blank sheets of paper to remove moisture inside the machine.
Determines how the printer handles a print job when the specified paper size
and type is not loaded in the tray.
Off: The job does not print if the specified paper size/type is not loaded in the
tray. The job will execute once the specified paper size/type is loaded.
On: The job prints even if the specified paper size/type is not loaded in the tray.
Determines whether to print on A4 paper if LT size paper is specified in the printer
driver, and vice versa.
Default: Off
Switches the energy saving function on/off. When this function is on, the printer
will automatically shut down some of its functions automatically after it remains
idle for the prescribed amount of time.
The "E. Saver Timer" can be set for 5, 15, 30, 35, 60 min.
Once the printer enters the energy save mode, it will require some time to recover
full operation once it receives a print job.
Determines whether a notification is sent to a specified email address when a
printer error occurs. Be sure to cycle the printer off/on after doing this setting.
Determines the units of measure ("mm" or "in.") Default: mm
Sets the ink storage counter after the ink collector unit is replaced.
The direction of printing (uni- or bi-directional) is determined by the setting of
the envelope selector.
• When the selector is set to the rear, printing is uni-directional for envelopes
• When set forward printing is uni-directional or bi-directional depending
on the paper type.
This feature menu item has two setting:
• Display Alert (default). An alert is displayed if the envelope selector is back
and set for envelope printing.
• No Alert & Print. No alert is displayed. A message prints to tell the operator
that the envelope selector is set for envelope printing.
Determines how long the printer waits for the interface to respond. After the
specified time elapses, the printer can receive data from another interface. If the
specified time is too short, a timeout might occur while a data transfer is in
progress. If this occurs, the print job will be interrupted by a new job from another
interface. Default: 15 sec.
Use to do the network settings.
Setting Default
DHCP On
IP Address 0.0.0.0
Subnet Mask 0.0.0.0
Gateway Address 0.0.0.0
Active Protocol All Active
Ethernet Speed Auto Select
Two settings are available:
USB Speed.
• Auto: 480 Mbps or 12 Mbps automatically adjusted
• Full Speed: 12 Mbps fixed
Default: Auto. Normally, this setting does not require changing.
Port Setting.
Specifies communication settings for a USB connection.
On/Off Default: Off
Determines the language used for all prompts and messages on the operation
15