Saving The Registration Memory - Yamaha PSR-S650 Owner's Manual

Saving the Registration Memory

All 64 setups memorized to the Registration Memory
can be saved to the USB flash memory as a single file
(extension: usr).
1
Make sure that a formatted USB flash
memory has been properly connected
to the USB TO DEVICE terminal, then
call up the FILE CONTROL display
(page 55).
2
Use the CATEGORY [<] and [>] buttons
to select "Regist Save."
A default file name will automatically be created.
To Overwrite an Existing File
If you want to overwrite a file that already exists
in USB flash memory, use the dial or the [-/NO]
and [+/YES] buttons to select the file, then go to
step 5.
NOTE
• If there is not enough capacity left in the USB flash
memory, a message will appear in the display and you
cannot save the data. Erase unnecessary files from the
USB flash memory to make more memory available
(page 60).
3
Press the [EXECUTE] button.
A cursor will appear below the first character in
the file name.
4
Change the file name as necessary.
• The [1] button moves the cursor to the left, and
the [2] button moves it to the right.
• Use the dial to select a character for the current
cursor location.
• The [8] button deletes the character at the cur-
sor location.
Cursor
left
5
Press the [EXECUTE] button.
The display prompts you for confirmation. You
can cancel the save operation at this message by
Regist Save
pressing the [-/NO] button.
6
Press the [EXECUTE] button again, or
the [+/YES] button to execute the save
operation.
NOTICE
7
When the operation is complete, a "Com-
pleted" message appears briefly, then
returns to the display of step 2. Press the
[EXIT] button to exit from the FILE CON-
TROL display.
The Registration Memory file will be saved to the
USER FILE folder in the USB flash memory.
9. Using USB Flash Memory
Cursor Delete
right character
• The amount of time it may take to perform the save
operation depends on the status of the USB flash
memory. Even if this takes a long time, never turn off
the power or remove the USB flash memory during
this operation. Doing so could result in damage to the
data.
NOTE
• If an existing file name is specified, the display prompts
you for confirmation. Press [EXECUTE] or [+/YES] if it is
OK to overwrite the file, or [-/NO] to cancel.
NOTE
• Perform the Load operation (page 59) if you want to
recall the Registration Memory file on the USB flash
memory to the instrument.
Select characters
Cursor
57
Owner's Manual