Epson SureColor S30670 User Manual page 97

Heating & Drying
Set the temperature of the heaters or turn the fan for the additional print drying system on
or off (included with the S50670 and optional with other models).
Note:
Adjust heater temperature as follows:
❏ Set the heaters to the temperatures recommended in the documentation provided with the
media, if available.
❏ Raise the temperature if the print results are blurred or smudged or the ink clots. Note,
however, that raising the temperature too high can cause the media to shrink, wrinkle, or
deteriorate.
This section details the steps involved in setting the temperature for the heaters.
1. Use the d/u buttons to select Heating & Drying and press the Z button.
2. Select Heater Temperature and press the Z button.
3. You can set the temperatures of the pre-heater, platen heater, and after heater.
Use the r/l buttons to select a heater. From left, the options are pre-heater, platen
heater, and after heater.
After selecting the desired heater, use the d/u buttons to choose the temperature.
4. Select the desired option and press the Z button.
5. Press the y button twice to return to the customize settings menu.
Media Suction
While printing, the printer uses suction to provide the pressure needed to maintain the
correct distance between the media and the print head; the amount of pressure required
varies with the type of media. Less suction is used for thin media that would not print or
feed correctly at high levels of suction.
1. Use the d/u buttons to select Media Suction and press the Z button.
2. Use the d/ u buttons to choose a value.
3. Select the desired option and press the Z button.
4. Press the y button to return to the customize settings menu.
97
Basic Operations