Download Print this page

Kenmore 415.16649011 Use & Care Manual page 8

Liquid propane gas grill

Advertisement

Main
Burner
ignitor
Lighting
A
Do not lean
over grill
while
lighting.
I. Turn OFF all Gas
Burner
Control
Valves.
2. Turn ON
gas
source
or tank.
3. Open
lid during
Lighting.
4. Push and turn
main
burner
control
knob
to _
and
hold
in.
You will
hear
a clicking
sound
as the burner
is being
ignited.
Ignition
should
occur
within
5 seconds,
but
continue
to hold
the knob
in for a full
10 seconds
to
maintain
ignition.
5. Once
burner
has ignited,
turn
knob
to desired
setting.
6. If Ignition
does
NOT
occur
in 5 seconds,
turn
the burner
control
to OFF,
wait
5 minutes
for
gas to clear
away,
and
repeat
the lighting
procedure.
7. Repeat
steps
4 through
6 for
the remaining
main
burners.
Searing Sideburner
Ignltor Lighting
A
Do not lean over grill while lighting.
1. Open lld during lighting. Turn on gas at LP cylinder.
2. Push and turn control
knob to _
and hold in. You will
hear a clicking
sound as the burner is being ignited.
Ignition
should occur within 5 seconds, but continue
to
hold the knob in for a full 10 seconds to maintain
ignition.
3. Once burner has ignited,
turn knob to desired setting.
4. If ignition
does NOT occur in 5 seconds, turn the burner
control OFF. Wait
5 minutes for gas to clear away, and
repeat the lighting
procedure.
Rotisserie
Burner
Ignltor
Lighting
A
Do not lean over grill while lighting.
1. Open lld during lighting.
Turn on gas at LP cylinder.
2. Push and turn control
knob to_
and hold in. You will
hear a clicking
sound as the burner is being ignited.
Ignition
should occur within 5 seconds, but continue
to
hold the knob in for a full 10 seconds to maintain
ignition.
3. Once burner has ignited, turn knob to desired setting.
4. If ignition does NOT occur in 5 seconds, turn the burner
control OFF. Wait
5 minutes for gas to clear away, and
repeat the lighting
procedure.
Match-Lightlng
A
Do not lean over grill while
lighting.
A
Open lid. Turn on gas at LP cylinder.
A
Light Burners
one at time.
Match Lighting
the Main Burners
1. Place match into match holder (hanging
from right cart
side).
2. Strike the match and position
lit match through
match
light hole on RH side of cart. Shown Figure A.
3. Position lit match next to burner.
Shown Figure B.
4. Push in and turn far right control
knob to ,_
position.
Be sure burner lights and stays lit.
5. If ignition
does NOT occur in 5 seconds, turn the burner
control
knob OFF, wait 5 minutes for gas to clear away,
and repeat the lighting
procedure.
6. Light other burners in sequence from right to left by
pushing knob in and turning
to ,_
position.
Figure A
Figure B
Match lighting the Rotisserie
Burner - Figure C
1. Place match in match holder. Strike the Match.
Position lit
match close to the front center of the rotisserie
burner.
2. Push in and turn rotisserie
burner control knob to _
. Be
sure burner lights and stays lit.
3. If ignition does NOT occur in 5 seconds, turn the burner
control
knob OFF, wait 5 minutes for gas to clear away,
and repeat the lighting procedure.
Turn controls and gas source or tank OFF when not
in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure, if the burner does not ignite with
the valve
open, gas will continue to flow out of the
burner and could accldently
ignite with risk of injury
Figure C
Match lighting the Searing Sideburner
- Figure D
1. Place match in matchholder.
Strike the Match.
Position lit
match close to the Searing
burner.
2. Push in and turn Searing
burner
knob to _
position.
Be sure
burner lights and stays lit.
3. If ignition
does NOT occur in 5
seconds, turn the burner control
knob OFF, wait 5 minutes for
gas to clear away, and repeat
the lighting
procedure.
8 ° 464224011
Figure D

Advertisement

loading