GE Profile DPGT750 Owner's Manual And Installation Instructions page 32

Installation Instructions
EXHAUSTING THE DRYER (cont.)
BEFORE YOU BEGIN
Remove any lint from the wall exhaust
opening.
Ductlnternal _ Wall
Opening __!_i. " _ Check that
_,_\ _.l exhaust hood
F_ J_._"'_qi damper opens
and closes freely.
STANDARD REAR EXHAUST
We recommend that you install your
dryer before installing your washer. This
will permit direct access for easier exhaust
connection.
Slide the end of the exhaust duct underneath
the clips on the back of the dryer and secure
with duct tape or a hose clamp.
Duct
Clip
NOTE: We strongly recommend using rigid
metal exhaust duct. If using semi-rigid metal
duct, cut it to the proper length and avoid
bunching of the duct behind the dryer.
• For straight-line installation, connect the
dryer exhaust to the wall using duct tape.
Wall Side
Dryer
Side
RECOMMENDED CONFIGURATION
TO MINIMIZE EXHAUST BLOCKAGE
Using duct elbows will prevent duct kinking
and collapsing.
Transition
Ducting ._
DRYER EXHAUST TO SIDE OR
BOTTOM OF CABINET
If you wish to exhaust your dryer to the side
or bottom of the cabinet, order exhaust kit
14-A003, available from your GE supplier.
32