Installation Instructions; Before You Begin - GE Profile DPGT750 Owner's Manual And Installation Instructions

Installation
Instructions
Dryer
DPGT750
I Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: ge.com
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
• IMPORTANT - Save t hese
instructions for local electrical inspector's
use.
• IMPORTANT - Observe all
governing
codes and ordinances,
• Note to Installer - Be sure to leave these
instructions with the Consumer.
• Note to Consumer - Keep these instructions
for future reference.
• This dryer must be exhausted to the
outdoors.
• Before the old dryer is removed from service
or discarded, remove the dryer door.
• Service information and the wiring diagram
are located in the control console.
• Do not allow children on or in the appliance.
Close supervision of children is necessary
when the appliance is used near children.
• Proper installation is the responsibility of
the installer.
• Product failure due to improper installation
is not covered under the Warranty.
• Gas dryers are not approved for mobile
home installation.
FOR YOUR SAFETY:
WARNING
Use only rigid metal or flexible metal 4-inch
diameter ductwork for exhausting to the
outdoors. Never use plastic or other
combustible easy-to-puncture ductwork.
This appliance must be properly
grounded and installed as described in
these instructions.
• Do not install or store appliance in an area
where it will be exposed to water and/or
weather.
The National Fuel Gas Code restricts
installations of gas appliances in garages.
They must be 18 inches off the ground and
protected by a barrier from vehicles,
Install the dryer where the temperature is
above 50°F for satisfactory operation of the
dryer control system.
FOR GAS MODELS ONLY:
NOTE: Installation and service of this dryer
must be performed by a qualified installer,
service agency or the gas supplier.
In the Commonwealth of Massachusetts:
• This product must be installed by
a licensed plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be T-handle-type.
• A flexible gas connector, when used,
must not exceed 3 feet.
I
18