Summary Screen - GE Profile DPGT750 Owner's Manual And Installation Instructions

Summary Screen
,_'g. (7 o 112
About the
Drying
Options
Touch tile OPTIONS pad on tile Touch Screen
to select dlying options. _MfeI"selecting any drying
options, press OK to save your setting.
Delay Start
Touch the DELAY START pad repeatedly to set a
delay time ot up to 12 hom_. Tile countdown time
will be shown ill tile display.
Extended 7hmble
Minimizes wrinkles b)' adding ai_pro_nmtely
20 ininutes ot no-heat tunlbling alter clothes are
dry. Touch EXTENDED TUMBLE to turn tile
teatui'e on or off. If set, the Extended Tuinble tiine
will not be included in the cvcle tiine shown in the
display. The dia'er will signal ti)r the fii_t 6 ininums
during Extended Tuinble.
End-oflC)vle S(gnal
Alerts you that the cycle is complete. The clothes
should be reinoved when the beeper goes offso
wrinkles won't set in. Touch END OF CYCLE
SIGNAL to select tile vohune or to turn tile
beeper off'. Tile new vohune will be saved as tile
detilult setting.
OPTIONS
)DELAY START 1 HOUR
EXTENDEDTUMBLE
)
,))1
(on some models)
OPTIONS
I OEL,, } { EXTE°OE
]
START TUMBLE
END OF CYCLE SIGNAL _))) }
Agljusting the
7_me Settings
You can at!just tile time setting fi)r tile (liT cycle,
delay start and extended tulnble fillies. Touch tile
TIME pad on the Sulnlnai_' Screen; then choose
the tilne you wish to at!just.
To chmage the dry cycle time, select CYCLE TIME;
then use the ai'i'o_vs to select inore or less drying
tilne. If the Cycle Tilne is changed, the dryness
sensor will be turned Off'.
To chmage the delay start or extended tumble thne,
select DELAY TIME or I?kXTENDED TUMBLE;
then tollow tile instructions in tile About tile
Dr)ing Options section.
ADJUST TiME SETTINGS
ICYCLETIMEI I DELAYTIME]
[ EXTENDED TUMBLE ]
About the
Cycle Status
ScH¢g?l
10
_Mfer you press START, a Cycle Status screen will
appear to indicate what wcle the (hwer is in and
the time remaining in the cycle.
DRYING - The dryer is sensing the moisture level
of tile load.
SENSING - Tile (h) er is detei_nining if tile correct
dryness lexel has been reached.
COOL DOWN - Tile load is dry and may be
removed (tile diyer will continue to blow cool air
fi)r tlI) to 5 ininutes).
EXTENDH) TUMBLE - Tile load is dry and may
be relnoved (tile
druln
will continue to turn
without heat t0r
tl I) [O 20 Illinu[es).
CYCLE STATUS
CHANGE SETTINGS
DRYING