Dispenser; The Light; Bulbs; Replacing The Light Bulbs - GE Model 42 Owner's Manual And Installation Instructions

Replacing the light bulbs.
Setting the controls to OFF does not remove power to the light circuit.
....................................................................................... Refrigerator Compartment--Upper Light
(appearance may vary)
@ Raise tile gl_ille panel, set tile master
power switch to tile 0 (off)position and
allow lamps to cool.
@ To x'emove the light shield, press on the
sides of tile shield and pull down.
@ Replace tile bulbs with appliance bulbs
of the same or lower wattage. Replace
the shield by engaging the bottom tab
into tile slot and aI)plying light torward
pressure/mtil tile shield snaps in place.
@ Set tile master power switch h) tile I (On)
position and close tile grille panel.
Refrigerator Compartment--Lower Light
This hght is located above the top drawe_
@ Raise tile gl_ille panel, set tile master
power switch to tile 0 (Off)position and
allow lamps to cool.
Remove items flxm_ tile shelf above tile
light shield. Remove the shel£
Use both hands to grasp each end of
the light shield. Press in on the bottom
of the shield with your thumbs while
rotating tile cover up and out.
Replace tile bull) with an appliance
bulb of tile same or lower wattage.
Replace tile shield by engaging tile
bottoln tab into tile slot and appl)ing
light forward pressm'e tmtil tile shield
snaps in place.
O Set tile inaster power switch to tile I (Oil)
position and close tile grille panel.
Freezer Compartment
@ Raise tile grille panel, set tile master
power switch to tile 0 (Of) position and
allow lamps to cool.
@ Reinoxe tile items ti'()m tile shelf just
below the light shield. Remoxe the
shel£
@
To remoxe tile light shield, press down
on the top of the shield and pull the
tabs out of the slots. Tilt the shield
fi)rward and out.
Replace tile bull) with an appliance
bulb of the same or lower wattage,
and reinstall the light shield. Replace
the shield by engaging the bottom tab
into tile slot and apI)lying light forward
pressm'e tmtil tile shield snaps in place.
O Set tile master power switch to tile I (on]
position and close tile grille panel.
Dispenser
@ Raise tile grille panel, set tile master
power switch to the 0 (off} position and
allow lamps to cool.
@ Tile bulb is located in tile dispenser
trader the control panel. Remove the
two screws fl'om the light shield. Slide
the light shield toward the dispenser to
disengage the tabs, then remove the
light shield. Remove the light bulb b v
turning it co/mterclockwise.
Replace tile bulb with a bulb of tile
same size and wattage. Replace the
light shield by sliding the tabs into
the slots in the fl'ont of the dispenser.
Replace the two screws.
@ Set tile master power switch to tile I (0/1)
position and dose tile grille panel.
14