GE Model 42 Owner's Manual And Installation Instructions page 35

Installation Instructions
START ICEMAKER
_Power Switch
_GreenPowerLight
* Flip the switch to I (ON). The icemaker will
begin operation automatically.
• Make sure nothing interferes with the
sweep of the feeler arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, set the switch to
O (OFF).
INSTALL TOEKICK
• Locate the supplied toekick (shipped taped
to the top of the refrigerator). Install with
2 screws provided.
SuppliedToekick
%
• The vented toekick must remain unobstructed
for proper air flow.
DOOR ALIGNMENT
• Stand back from the refrigerator to inspect
the door alignment.
• Shipping or the addition of heavy door
panels may have caused the doors to move
slightly out of alignment.
Clockwise
• If necessary, the Fresh Food door may
be adjusted up or down to align with the
Freezer door.
• Loosen the leveling mechanism.
• Use a 7/32" wrench to adjust the hinge pin
as shown.
• Tighten the leveling mechanism.
IMPORTANT NOTE: After the unit has been
leveled, if the fresh food door is higher than
the freezer door, adjust the front right leveling
leg lower to align the doors and, if required,
raise the left leveling leg to level the unit side
to side.
35