GE Model 42 Owner's Manual And Installation Instructions page 34

Installation Instructions
CONNECT WATER SUPPLY
Check to make sure that Master Power
switch is in the O (OFF) position,
I
• Locate and bring GE SmartConnect T'_ t ubing
to the front of the cabinet.
• Turn the water on to flush debris from line.
Run about a quart of water through tubing
into a bucket, then shut off water.
Copper Tubing
• Slip a 1/4" nut and ferrule onto end of
copper tubing. Insert tube into the union
fitting on the unit and tighten nut to union.
• Turn on the water to check for leaks.
GE SmartConnect
TM
Tubing
• Insert the molded end of the tubing into
the refrigerator connection. Tighten the
compression nut until it is just hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks.
• Turn on the water to check for leaks.
Note: Make sure excess tubing length does
not interfere with toekick installation.
TURN ON THE POWER
• Set the Master Power switch to the I (ON)
position.
• Check to make sure power to refrigerator is
on by opening refrigerator door to see if
interior lights are on.
Master
PowerSwitch
Water Filter
• The temperature controls are preset at 37 °
for the Fresh Food section and 0 ° for the
Freezer section.
• Allow 24 hours to stabilize before making
adjustments.
34