Screen Burn Protection
Configures the Screen Burn Protection options to prevent and reduce pixel burn.
When an image remains in one position too long, it may cause a permanent burn on the screen.
Preventing Screen Burn=in
To reduce the possibility of screen burn, this unit is equipped with screen burn prevention technology. This technology enables you
to set picture movement up/down (Vertical Line) and side to side (Horizontal Dot).
The Time setting allows you to program the time between movement of the picture in minutes.
•
Pixe! Shift: Using this function, you can minutely move pixels on the PDP in horizontal or vertical direction to prevent after-
images on the screen.
Optimum condition for pixel shift;
Horizontal
0--4
2
0_4
2
1~4 rain.
2 min.
Side Gray: When you watch TV with the screen ratio of 4:3, the screen is prevented from any damage by adjusting the white
balance on both extreme left and right sides. To prevent the screen burn from happening, select Dark or Light.
- Dark: When you set the screen ratio to 4:3, it darkens the left and right sides.
- Light: When you set the screen ratio to 4:3, it brightens the left and right sides.
Reducing the Effects of Screen Burn
If screen burn has occurred, you can select scrolling to help remove screen burn artifacts.
•
Scrolling: This function removes after-images on the screen by moving all the pixels on the PDP according to a pattern.
Use this function when there are remaining after-images or symbols on the screen, especially when you displayed a still image
on the screen for a long time.
The after-image removal function has to be executed for a long time (approximately I hour) to effectively remove after-
images on the screen. If the after-image is not removed after performing the function, repeat the function again.
Press any key on the remote control to cancel this feature.
[]
PictureReset _ ResetPictureMode / Cancel
Resets all picture settings to the default values,
Select a picture mode to be reset. The reset is performed for each picture mode.