Hayward TigerShark® Owner's Manual page 8

TROUBLESHOOTING THE REMOTE CONTROL FUNCTION
If the TigerShark Plus does not turn when the remote control is activated:
• To operate this Remote Control you must press on the ARROW buttons (along the right side of this remote). Pressing on
the text buttons (along the left side of this remote) will not operate your cleaner.
• Be sure to aim hand held toward power supply, not the unit.
• Be sure there are no obstructions between the remote control and the power supply.
• The distance between the remote control and power supply should not exceed 75 feet. Moving closer will ensure better
reception.
• The batteries in the remote control may need to be replaced. (Requires one CR2032 lithium battery)
• The overload protection breaker located on the front of the power supply may be tripped. To reset depress the small black
button located above the flotation cord connection on the power supply.
• The Turning Foot may be lodged with debris. Turn cleaner off and remove from the pool. Manually work foot in and out to
clear any debris, foot should slide easily.
• For remote control units with foam rollers, before operating the transmitter, cleaner must be in water for at least 15
minutes to avoid cleaner from floating.
Page 8 of 16
HAND HELD REMOTE CONTROL
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER ISRC10202 REV C