Hayward TigerShark® Owner's Manual page 10

Tigershark series robotic pool cleaner
Hide thumbs Also See for TigerShark®:
Table of Contents

Advertisement

Clean the filter cartridge after each use:
• Place the TigerShark on its side. Release the bottom lid latches (page 13, Fig. d) and remove the bottom lid assembly (page
14, Fig. e).
• Pull out the filter cartridge. Your cartridge is a three piece filter assembly (Part# RCX70100) that you may or may not
remove the elements (Part# RCX70101) for thorough cleaning. Using a garden hose with a spray nozzle, pressure-wash the
filter elements to remove debris. Hold the filter elements as shown to allow the debris to fall out (page 14, Fig. f).
• Wash the inside of the bottom lid.
• Replace the filter cartridge into the TigerShark (page, 14 Fig. g).
• Install bottom lid and slide latches into lock position.
• Filter cleaning solution can be used to remove D.E., excessive dirt and/or sand.
Remember: The cleaner your filter is, the more efficient your unit will perform.
Periodic Cleaning of Moving Parts
WARNING: Disconnect the power supply from electrical outlet before cleaning moving parts.
• Inspect the pump outlet to ensure that no debris or hair has clogged the impeller. The impeller can be cleaned by removing
the impeller tube (page 9, #9) by twisting (rotating) it (page 6, Fig 2).
• Remove any debris that has accumulated between the tracks (page 9, #10) and wheels (page9, #11).
When it is out of the water, store your TigerShark on its side in a dry, shady location at temperatures between 40ºF - 115ºF.
Storage
With continued use, the cable may become coiled (like a telephone cord). To correct this, lock the handle in the opposite
Cable Care
diagonal position (page 13, Fig. b). The TigerShark will then circle the pool in the opposite direction and uncoil the cable. Also,
periodically stretching the cord out in the sun should remove any cord twists.
Reverse handle position after each use to avoid cable coiling.
The cable should be checked periodically for any external damage.
IMPORTANT:
If the supply cord is damaged, it must be replaced by manufacture, its service agent, or a similarly qualified person in
order to avoid a hazard.
Page 10 of 16
MAINTENANCE
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents