Hayward TigerShark Series Manual
  1. Manuals
  2. Brands
  3. Hayward Manuals
  4. Swimming Pool Vacuum
  5. TigerShark Series
  6. Manual

Hayward TigerShark Series Manual

Robotic cleaner
Hide thumbs Also See for TigerShark Series:
Table of Contents

Advertisement

Quick Links

Download this manual
Hayward Pool Products
Hayward Pool Products Canada
620 Division Street
2880 Plymouth Drive
Elizabeth, NJ 07207
Oakville, ON L6H 5R4
www.haywardpool.ca
www.hayward.com
TigerShark Series
Robotic Cleaner
»»»
Hayward Pool Europe
1070 Allée des Chênes
01150 St-Vulbas, France
www.hayward.fr
www.hayward-pool.com
+
PART #R-QRG0990
®
Hayward Pool Products (Australia) Pty Ltd.
Melbourne-Sydney-Brisbane-Perth
P.O Box 4384, Dandenong South VIC. 3164
www.hayward-pool.com.au

Advertisement

Table of Contents
loading

Related Manuals for Hayward TigerShark Series

Summary of Contents for Hayward TigerShark Series

  • Page 1 TigerShark Series ® Robotic Cleaner »»» Hayward Pool Products Hayward Pool Products Canada Hayward Pool Europe Hayward Pool Products (Australia) Pty Ltd. 620 Division Street 2880 Plymouth Drive 1070 Allée des Chênes Melbourne-Sydney-Brisbane-Perth Elizabeth, NJ 07207 Oakville, ON L6H 5R4 01150 St-Vulbas, France P.O Box 4384, Dandenong South VIC.

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be observed including the following. Failure to adhere to the safety warnings below may result in severe injury, death or property damage. READ AND FOLLOW ALL INSTRUCTIONS This is the safety-alert symbol.

  • Page 3: Operating Conditions

    OPERATION INSTRUCTIONS AND IMPORTANT INFORMATION READ BEFORE USING THE CLEANER OPERATING CONDITIONS • Water temperature operation range: min 50°F / 10°C, • Do not operate outside the pool. This will damage the motor max 95°F / 35°C. Maximum operating depth: 3 m (10 ft.) seal and void the warranty.
  • Page 4 Pool Preparation pH: 7.2 - 7.8 Chlorine: 1.0-3.0 PPM Total Alkalinity: 80 - 120 PPM 50˚- 100˚F 10˚- 37˚C >3.0 PPM POOL PREPARATION • NEVER SWIM WITH THE CLEANER IN THE POOL. 3. Check the water chemistry. The water should be properly balanced (pH level), and the pool free from •...
  • Page 5 Control Unit Set-Up INSTALL The TigerShark Control Unit can be installed and • The cleaner control unit should be located at least used in different locations: 3.5 m (11.5 ft.) from the closest edge to the pool. Sitting on a table or on the pool deck •...

  • Page 6: Power Cable

    POWER CABLE • To minimize cord twisting, completely unroll and straighten the cable before putting the cleaner the pool. CLEANER LOCATION • It is ideal to have the control unit positioned near the midpoint of your pool (lengthwise). • Depending on the size and shape of your pool, the entire length of the floating cable may not be necessary.

  • Page 7: Starting The Cleaner

    STARTING THE CLEANER REGULAR MODEL ~4 hrs. ~4 hrs. QC MODEL QUIK CLEAN ~90 min. FULL ~4 hrs. CYCLE CLEANING CYCLE CLEANING CYCLE • During its cleaning cycle the cleaner may not climb the wall or any vertical surfaces every time. It will adjust its cleaning sequence to offer optimal pool coverage.

  • Page 8: Removing The Cleaner From The Pool

    REMOVING THE CLEANER FROM THE POOL When the cleaning cycle is completed and the cleaner is either in sleep mode (Start/Stop button light is solid blue) or in stand-by mode (Start/Stop button light is blinking green), The TigerShark Series can be easily removed from the pool by using the handle on the cleaner.
  • Page 9 STORING THE CLEANER AND CADDY CART • When not in the pool, keep the cleaner away from direct sunlight or store it in a protected area. • For winter storage, store the cleaner in a place where it will be protected from cold temperatures. •...
  • Page 10 If TigerShark fails to pick up fine or heavy debris: • Clean the filter. It may be clogged. • Clip the high velocity inlet to the bottom lid. This inlet creates extra suction for lifting fine or heavy debris. This part also can be helpful if unit becomes routinely stuck on a raised main drain.
  • Page 11 TS IEC 60364-7-702 Use Only Genuine Hayward Replacement Parts N’utilisez que des pièces détachées d’origine Hayward Utilice únicamente piezas de repuesto originales de Hayward Utilizzare esclusivamente pezzi di ricambio originali Hayward Verwenden Sie nur Original-Ersatzteile von Hayward Gebruik uitsluitend originele Hayward-onderdelen Utilize apenas peças sobresselentes de origem Hayward...

Table of Contents