Electrolux EI27EW45KB Use And Care Manual page 28

28
Solutions to common problems
Before you call for service, review the following list. It may save you time & expense. The list includes
common occurrences that are not the result of defective workmanship or materials in this appliance.
IMPORTANT
Before calling for service, review this list. It may save you both time and expense. This list includes
common experiences that are not the result of defective workmanship or material in your cooktop.
Problem
Oven control
beeps and
displays an F
error code.
Installation
Entire range does
not operate
Oven light does
not work
Self-cleaning
cycle does not
work
Poor cooking
results
Flames inside
oven or smoking
from oven vent
Solution
• Electronic control has detected a fault condition. Push CANCEl pad to clear
the display and stop the display from beeping. Reprogram the oven. If a fault
reoccurs, record the fault number, push the CANCEl pad and contact an
authorized servicer.
• Place oven rack in center of oven. Place a level on the oven rack. Contact
installing agent if rack and cabinet cutout flooring are not level.
• Kitchen cabinet misalignment may make range appear to be not level. Be sure
cabinets are square and level. Contact cabinet maker to correct problem.
• When the range is first plugged in, or when the power supply to the oven has been
interrupted, the display will flash. The range cannot be programmed until the clock
is set.
• Be sure electrical cord is securely connected into the electrical junction box.
• Cord/plug is not installed and/or connected. Cord is not supplied with range.
Contact your dealer, installing agent or authorized servicer.
• Service wiring not complete. Contact your dealer, installing agent or authorized
servicer.
• Power outage. Check house lights to be sure. Call your local electric company.
• Short in cord/plug. Replace cord/plug.
• Controls are not set properly. See instructions to set the controls.
• House fuse has blown or circuit breaker has tripped immediately following
installation.
• House fuse may not be fully engaged. Check fuse and screw or engage circuit
breaker securely.
• Burned-out or loose bulb. Follow the instructions under Oven light to replace
or tighten the bulb.
• Make sure the oven door is closed.
• Make sure you have removed the oven racks and the oven rack supports from
the oven.
• Controls not set properly. Follow instructions under "Using the Self-Clean
Feature".
• Many factors affect baking results. See baking for hints, cause and corrections.
See Adjusting Oven Temperature.
• Adjust the recipe's recommended power levels or cooking times.
• Cookware is too lightweight or warped. Use heavier quality cookware so foods
being prepared may cook more evenly.
• Excessive spillovers in oven. For example this will happen for pie spillovers or
large amounts of grease left on the oven bottom. Wipe up excessive spillovers
before starting oven.
Questions or for service call: 1-877-4ELECTROlUX
Before you call
(1-877-435-3287)