Introduction; Features - EnGenius EOC2611P User Manual

EnGenius EOC2611P
1 Introduction
EOC2611P is a long range outdoor wireless Access Point / Client Bridge that operates seamlessly in the
2.4GHz frequency spectrum and provides high bandwidth up to 108Mbps with Super G. With dual
polarization antenna, it features high transmitted output power and high receivable sensitivity. High
output power and high sensitivity can extend range and coverage to reduce the roaming between
Access Points to get a more stable wireless connection. It also reduces the expense of equipment in the
same environment. With IPx4 protection, it can provide effective in keeping out water.
It supports distance control by 1km to 30km and RSSI indicator which enables the best transmit and
receive signals for traffic communication. This product comes with PoE injector for building in outdoor
environment easily.
To protect your wireless connectivity, it can encrypt all wireless transmissions through 64/128/152‐bit
WEP data encryption and also supports WPA/WPA2. The MAC address filter lets you select exactly
which stations should have access to your network. In addition, the User Isolation function can protect
the private network between client users.
The attractive design, high performance, and array of features make EOC2611P a suitable wireless
solution for your residence or office.
1.1 Features
Wireless
High output power Transmit high output power programmable for different country selections
10dBi Internal Antenna Built‐in 10dBi Dual Polarization Antenna for superior performance
External Antenna SMA connector to attach higher gain antenna
High Data Rate High speed transmitting rate up to 54Mbps, support large payload
Multifunction application Access Point/Client Bridge/Client Router/WDS Bridge
Long range transmitting Transmit power control and distance control (ACK timeout)
Narrow Bandwidth Provides 5MHz/10MHz/20MHz bandwidth selection
Signal Strength Display RF signal strength status shown with 3 color LEDs for easy deployment
to find the best signal reception.
Multiple SSID 4 SSID supported. Each SSID can set itself wireless or WAN access setting
AP Detection Scan all neighboring APs with their channels and signal strength
QoS(WMM) Enhance performance and density
Networking
PPPoE Point‐to‐Point Protocol over Ethernet in Client Router mode.
PPTP Point‐to‐Point Tunneling Protocol (PPTP) is a method for implementing virtual private
networks
VPN Pass Through
Version 1.0
6