Konica Minolta bizhub C654 User Manual page 49

Troubleshooting
Error Message
Can not scan due to device
error that has occurred.
Can not start scanning be-
cause you have reached the
maximum number of regis-
tered jobs.
Device busy. Can not begin
scan.
Unable to start scanning be-
cause Power save mode is set
to the device.
Cancel Power save mode us-
ing the method below and
click OK to restart scanning.
• Turn the sub power switch
ON when it is OFF.
• Press Power Save Key
when the sub power switch
is ON.
Failed to start scanning again
because Power save mode is
set to the device.
Scanning has been cancelled.
Scan Error Occurred.
Error occurred while commu-
nication with the device.
Can not scan because scan-
ning is restricted.
TWAIN driver
Cause
A device error has occurred.
The number of registered jobs
has reached the maximum
value.
The device is currently being
used or is in a state in which it
cannot be used.
The device cannot start scan-
ning because it is in low-pow-
er mode.
The device cannot start scan-
ning because it is in low-pow-
er mode.
The scan has been canceled
by the device.
A scanning error has oc-
curred.
An error occurred during com-
munication with the device.
Scanner transmission has
been forbidden in the user
privileges.
Corrective Action
Check the device conditions.
Wait awhile, and then try con-
necting again.
Wait awhile, and then try con-
necting again.
If the same message still ap-
pears after you wait awhile,
check with the administrator
of the device.
Use one of the following
methods to disable low power
mode, and then click OK.
Start scanning again.
• If the secondary power is
off, turn it on.
• If the secondary power is
on, press the power save
key.
Use one of the following
methods to disable low power
mode, and then scan again.
• If the secondary power is
off, turn it on.
• If the secondary power is
on, press the power save
key.
Check the device conditions.
Check the device conditions.
Check the network and device
conditions.
Check with the administrator
of the device.
9
9-2