Sending A Fax Using An Additional Line ([Select Line]); Using An Additional Line; Operations Required To Use This Function (For Administrators); Operation Flow - Konica Minolta bizhub C654 User Manual

4.8

Sending a fax using an additional line ([Select Line])

4.8 Sending a fax using an additional line ([Select Line])

Using an additional line

When two lines are operating, you can select a line for sending a fax.
Faxes are usually transmitted using an idle line. Lines can be used to transmit faxes according to usages 's
situation.
Tips
- When registering destinations with an address book, you can configure the lines used to transmit faxes
in addition to registering fax numbers.
- This function cannot be used together with the following functions.
– Polling TX, Polling TX (Bulletin Board).

Operations required to use this function (for administrators)

Configure a specific function for additional line. If you configure a function that differs from the one assigned
to the first line, you can use the two lines differently.
For details on how to configure the settings, refer to page 11-25.
Tips
- You cannot specify a line if [Multi Line Usage Settings] is set to [RX Only].

Operation flow

1
Load the original.
2
Tap [Scan/Fax].
3
Specify the destination.
4
Tap [Application] - [Fax Setting] - [Line Setting].
bizhub C754/C654
4
4-14