Konica Minolta bizhub C550 User Manual page 189

Administrator mode
Item
TCP/IP*
Network Speed
IP Address Setting Meth-
od*
IP Address
Subnet Mask
Default Gateway
IPv6
RAW Port Number
Dynamic DNS Setting
Host Name
DNS Domain Name Set-
ting
DNS Server Setting
SLP Setting
LPD Setting
Reminder
In order to apply the changes to the settings for items which are marked
with an asterisk (*), restart the machine (turn it off, then on again).
When the machine is turned off, then on again, turn the machine off with
the [Power] (auxiliary power) key before turning off the main power
switch. In addition, wait at least 10 seconds to turn the machine on after
turning it off; otherwise, the machine may not operate correctly.
When using this machine under the IPv6 environment, there are the following
restrictions.
- Printing using SMB is not available (available for direct hosting service).
C550
Description
Select whether or not TCP/IP is used.
Select the operating speed.
Select whether the IP address is automatically acquired or is direct-
ly entered. If it is automatically acquired, select the check boxes to
specify the acquisition conditions.
Specify the IP address of the machine. (Format: ***.***.***.***; Range
for ***: 0 to 255)
Specify the subnet mask of the connected network. (Format:
***.***.***.***; Range for ***: 0 to 255)
Specify the default gateway for the connected network. (Format:
***.***.***.***; Range for ***: 0 to 255)
Select whether or not IPv6 is used.
If "ON" is selected, specify settings for the following.
• Auto IPv6 Setting*
• Global Address
• Prefix Length
• Gateway Address
Select the check box for the port to be used, and then type in the
port number. (Range: 1 to 65535)
Select whether or not Dynamic DNS is enabled.
If Dynamic DNS is enabled, type in the host name (up to 63 charac-
ters).
Select whether or not the DNS domain name is automatically ac-
quired. If it is not automatically acquired, type in the domain name
below (up to 253 characters).
A maximum of three DNS server addresses can be registered. (For-
mat: ***.***.***.***: Range for ***: 0 to 255)
If the machine is set to use IPv6, an IPv6 address can also be spec-
ified.
Select whether or not SLP is enabled.
Select whether or not LPD is enabled.
3
3-82