Top Sensor; Removing The Power Supply Assembly; Removing The High Voltage Power Supply Board; Removing The Cassette - Canon MF3110 - ImageCLASS Laser Multifunction Service Manual

2) Remove the 9 screws [1] to remove the power
supply shield plate [2].
[2]
[1] [1]
F-3-59
3.1.10.6 Removing the Power
Supply Assembly
1) Remove the 3 screws [1]. (The external cover is
omitted from the illustration below to show the
instructions clearly.)
2) Remove the four connectors [2] as well as the flat
cable [3] on the ECNT board.
[1]
[2]
[2]
F-3-60
[1]
0007-7707
[3]
[1]
3) As you remove the bosses on both sides [1], lower
the front part of the power supply assembly [2].
Then pull it to remove the power supply assembly.
[2]
[1]
F-3-61
3.1.10.7 Removing the High
Voltage Power Supply Board
1) Remove the flat cable [1].
2) Remove the 3 screws [2] and the high voltage
power supply board [3].
[2]
[3]
[1]
F-3-62

3.1.11 Top Sensor

3.1.11.1 Removing the Cassette

1) Remove the cassette by holding the cassette handle.
Chapter 3
0007-7709
0002-7635
3-15