24 electrolux
• Close the filter cover.
• Insert the mains plug again.
CLEANING THE WATER INLET
FILTERS
Important! If the appliance doesn't fill, it
takes a long time to fill with water, the
starting button flashes red or the display (if
WHAT TO DO IF...
The appliance does not start or stops dur-
ing operation. Certain problems are due to
lack of simple maintenance or oversights,
which can be solved with the help of the in-
dications described in the charts, without
calling out an engineer.
During appliance operation it is possible
that the red pilot light of the button 6 flash-
Fault code and mal-
function
Possible cause - Solution
available) shows the relevant alarm (see
chapter "What to do if..." for more details),
check if the water inlet filters are blocked .
To clean the water inlet filters:
• Turn off the water tap.
• Unscrew the hose from the tap.
• Clean the filter in the hose with a stiff
brush.
• Screw the hose back onto the tap. Make
sure the connection is tight.
• Unscrew the hose from the appliance.
Keep a towel nearby because some wa-
ter may flow.
• Clean the filter in the valve with a stiff
brush or with the piece of cloth.
• Screw the hose back to the appliance
and make sure the connection is tight.
• Turn on the water tap.
es and one of the indicator pilot lights illumi-
nates to indicate that the appliance is not
working.
Before contacting your local Service Cen-
tre, please carry out the checks listed be-
low.