Operation; Using The Temperature Control Panel - EdgeStar CWR460DZ Owner's Manual

Note: Whether your wine
cooler can reach the actual
set temperature depends on
the ambient environmental
conditions.
Caution: If you powered off
the unit, please wait at least
5 minutes before powering it
back on.
EdgeStar Wine Refrigerator

OPERATION

Using the Temperature Control Panel

Temp. Buttons
Run Light
RUN
Upper Zone Display
Use the up button to adjust the upper zone's temperature, and use the
down button to adjust the lower zone's temperature. The temperature
displayed can be in Fahrenheit or Celsius. This wine cooler has a
temperature range from 41°F to 54°F for the upper zone, and 54°F to
64°F for the lower zone.
This wine cooler has two displays, an Upper Zone Display that shows the
temperature in the top section, and a Lower Zone Display that shows the
temperature in the bottom section.
Press the button on the control panel to adjust the temperature in the
upper zone. The button will scroll the temperature by one degree
increments. Once you see the desired temperature, stop pressing the
button. Note: While pressing the button, it is normal for the temperature to
descend, and then jump to the highest available range. After about 5
seconds, the set temperature will revert to the current temperature.
Press the button on the control panel to adjust the temperature in the
lower zone. The button will scroll the temperature by one degree
increments. Once you see the desired temperature, stop pressing the
button. Note: While pressing the button, it is normal for the temperature to
descend, and then jump to the highest available range. After about 5
seconds, the set temperature will revert to the current temperature.
Allow at least 24 hours before storing your wines and to allow the
temperature to acclimate.
Press the button to turn the inner light on or off.
Press and hold the power button for approximately 3 seconds to turn the
unit's power on or off. The Run Light will illuminate when the unit is
cooling.
The Celsius or Fahrenheit light will be lit depending on what scale
temperature is being displayed. To switch between C and F, press and
hold the and buttons at the same time for approximately 5 seconds
until the temperature scale changes.
Light Button
Power Button
C F
Celsius and Fahrenheit
Lights
Lower Zone Display
8