Table of Contents
Advertisement
PA-600 AMPLIFIER SPECIFICATIONS
POWER OUTPUT
FREQUENCY RESPONSE
TOTAL HARMONIC DISTORTION
SLEW RATE
SIGNAL TO NOISE RATIO
LOAD IMPEDANCE
DAMPING FACTOR
CONTROLS
INPUT CONNECTIONS
OUTPUT CONNECTIONS
MODE SWITCHES
PROTECTION CIRCUITRY
COOLING
POWER REQUIREMENTS
SIZE AND WEIGHT
Specifications & features are subject to change without notice.
2 x 120 watts RMS @ 8 ohms 20Hz-20kHz (stereo mode)
2 x 200 watts RMS @ 4 ohms 20Hz-20kHz (stereo mode)
2 x 300 watts RMS @ 2 ohms 1kHz (stereo mode)
380 watts RMS @ 8 ohms 20Hz-20kHz (mono mode)
600 watts RMS @ 4 ohms 1kHz (mono mode)
+0/-0.5dB, 20Hz-20kHz
<0.05%, 20Hz-20kHz
40 volts / microsecond
> 89dB ref 200 watts /4 ohms (20kHz equivalent bandwidth)
2 ohms or greater in stereo mode
4 ohms or greater in mono mode
Typical 300 (1kHz, 8 ohms)
Two Front panel level setting knobs, one power switch
XLR, RCA and 1/4" phone (tip/ring/sleeve), one each channel
Binding posts each channel, Phone jacks(one each channel)
Mono Bridge mode select, Limiter "on"/"off"
Short circuit, open circuit, RF burnout, over temp, speaker protection relays,
turn on/off transient protection, DC protection, limiter circuitry
Variable speed forced air fan cooling rear/side intake, front exhaust
110 VAC 60Hz, 750VA
100-120 VAC 50/60Hz, 750VA
220-240 VAC 50/60Hz, 750VA
19" W x 3.49" H x 15.43" D; 29 lbs.
482.6mm W x 88.8mm H x 392mm D; 13.2 Kg.
-9-
www.earthquakesound.com
Advertisement
Table of Contents
