Table of Contents
Advertisement
PA-600 AMPLIFIER FRONT & REAR PANELS FUNCTIONS/CONNECTION.
7
1. POWER SWITCH:
This switch turns the amplifier on in the up position ("I" pressed in ) and off in the down
position. When AC power is applied to the amplifier, the power indicator led (#4)
illuminates.
2. LEVEL CONTROL (CH-1) & MONO:
This rotary potentiometer controls the sensitivity or gain of (CH-1). Set them to the level
needed for the desired output. When amplifier is set in the bridge mono mode, only this level
control (CH-1) is active in this mode.
3. LEVEL CONTROL CH2:
This rotary potentiometer controls the sensitivity or gain of CH2. Set them to the level
needed for the desired output. When amplifier is set in the bridge mono mode, this level
control is not active.
Specifications & features are subject to change without notice.
4
5
POWER
PROTECT PEAK
2 C H A N N E L S / 6 0 0 W A T T S P R O F E S S I O N A L B R I D G E A B L E A M P L I F I E R
1
8
9
18
11
12
11
6
SIGNAL
CH 1
LEVEL
MIN
MAX
MONO
2
10
14
14
12
13
13
4. POWER INDICATOR LED:
This Led illuminates when AC power is applied by means of the Power Switch (#1)
5. PROTECT INDICATOR LED'S:
These LED's illuminate whenever the internal protection relay for the channel is activated.
The protection relay is activated for a short period upon initial turn-on and at turn-off to
prevent transient "spikes" from being reproduced through your speakers. A protect condition
is also indicated if the unit gets too hot, or if DC voltages are present at the output. During
thermal protection, both channels are shut down. In the event of DC voltage on the output,
only the affected channel will be disconnected. The circuitry associated with the LED
indicators provides valuable protection for both the amplifier and your speakers.
-4-
6
5
SIGNAL
PEAK PROTECT
CH 2
LEVEL
MIN
MAX
3
15
7
16
17
www.earthquakesound.com
Advertisement
Table of Contents
