Advertisement
DUKANE
Intelligent Assembly Solutions
1
The System In interface connector is one of the primary communications links between the DPC II / II+ input port and
the user automation equipment. This connector provides the automation with dedicated communication lines that
allow the automation to control the beginning and the end of a welding sequence.
Pin Number
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Notes:
1. SH707 on the 110-3606 system I/O PCB must be configured to the JU728 position when this
common is used.
2. This input requires the optional 110-3938 press control module. Configuration of the SH901
Jumper on the 110-3938 press control module may also be required.
3. This input is configured for use as Automation End of Weld at the factory. Jumper SH704 must
be reconfigured on the 110-3606 System I/O board to permit use of the Isolated Automation
Stop feature.
4. The MPC probe bit functionality requires the optional MPC feature. The Setup bit functionality
is available on all DPC II+ systems. Please refer to the DPC manual for further details on this
feature.
© Dukane Corporation 2003. All rights reserved.
- 2 -
System Input Connector
DPC Signal Name
Power Supply
Ground
Isolated Operate Input
Isolated Input Common
Isolated Press Control
Not Used
Ground
Non Isolated Operate
Isolated Automation Stop /
Automation End of Weld
Not Used
Hand Probe Press Inhibit
MPC Probe/Setup Bit 0
MPC Probe/Setup Bit 1
MPC Probe/Setup Bit 2
Front Panel Control Lock
Dukane Corporation
2900 Dukane Drive Saint Charles, IL 60174 USA
Phone (630) 797-4900 FAX (630) 797-4949
http://www.dukane.com/us
A
p
p
l
i
c
a
t
A
p
p
l
i
c
a
DPC Signal Type
+22 VDC (250 mA max)
22VDC Return
Input
1
Common for pin 3, 5, 9
2
Input
Not Used
+22VDC Return
Input
Input
3
Not Used
Input
4
Input
4
Input
4
Input
Input
i
o
n
N
o
t
t
i
o
n
N
o
t
AN200
Rev 01
e
e
22102
2
Advertisement
